Posts in:Bearing Lubrication

Bearing Lubrication Infographic

Posted May 12, 2016 by admin

If you’ve been following our blog the past few weeks you’ve probably seen our posts Bearing Lubrication 101 and Bearing Lubrication 201. We wanted to quickly summarize those posts and present them in a fun, visually engaging way. If you missed these blogs you can always go back and read them, however this infographic covers a lot of the information that we covered on bearing lubrication. Check it out!

bearing lubrication infographic

 

If you’re following lubrication best practices and still experiencing bearing failure, contact VNC today. We can perform a bearing failure analysis to pinpoint the cause and help find a solution to your unique bearing challenge.

 

Bearing Lubrication 201- The Differences Between Oil & Grease

Posted April 26, 2016 by admin

In our post Lubrication 101 we took a brief overview of bearing lubrication and quickly outlined the importance that proper lubrication plays in promoting bearing life and performance. Now we are going to get a little more in depth and discuss some of the differences in properties and performance characteristics associated with both oil and grease.

 

Lubricant Type- Oil

Oil is going to be the best choice in the following circumstances/applications:

-applications that require extremely low torque or a narrow range of torque variation
-applications that exhibit high speeds and high operating temperatures

 

Lubricant Type- Grease

Grease is a mixture of fluid lubricant and a thickener dispersed in oil. As a lubricant for bearings, grease is going to be the best choice in the following circumstances/applications:

-systems or applications where an oil product would not be retained
-applications with slower operating speeds
-applications that require an added seal of protection from contamination and moisture

The composition of grease and its counterparts can be found in any arrangement of the following percentages.

Thickener        4- 20%

Base Oil           75- 96%

Additives         0- 8%

 

In order to decide which additive is right for your application or system, consider the following:

Additive Type              Capabilities

Antioxidant                  Prolongs life of base oil

Antiwear (EP)              Chemically active protection of loaded metal surfaces

Antirust                         Slows rusting of iron alloys

Anticorrosion               Slows corrosion of non-noble metals

Filler                              Thermal/electrical conductivity, special physical properties

Fortifier (EP)                Solids burnish into loaded surface under extreme pressures

Lubricity                        Reduces coefficient of friction, starting torque or stick/slip

Pour Point                    Improves lower temperature limit

Dye                                 Visual/UV markers as inspection/assembly aids

Viscosity Index            Reduces rate of change of viscosity with temperature

 

Advantages of Grease over Oil

There will be instances when oil will be a better choice of lubricant for your application. We discussed those circumstances at the beginning of the post. However, at VNC, we find that grease tends to be a better fit for an application due to the following reasons:

1. Ease of retention – stays in place
2. Minimal application – reduced maintenance cost
3. High reliability – historical reliability in electric motors
4. Protection – helps keep out moisture and contaminants
5. Clean – minimal leaking/dripping
6. Greased for life – ideal for inaccessible bearing applications

 

Whatever lubricant you choose, make sure you’ve considered all of the characteristics of your application and how it will need to perform. Bearings that are properly lubricated will have increased immunity to contamination, overloading, and premature failure.

If you have questions about what lubrication to use, contact us today! Our team can help you choose the right type and amount of lubrication for your application.